
Seller: Marketplace seller
$300
Asking
This usually takes 5-15 seconds. We're pulling together fitment data,
OEM numbers, and community knowledge...
Dusting off the service manual...
💡 This page improves over time as the community adds casting photos and confirms fitment
Roof Panel/Skin
This usually takes 5-15 seconds. We're pulling together fitment data,
OEM numbers, and community knowledge...
Dusting off the service manual...
💡 This page improves over time as the community adds casting photos and confirms fitment
Quick reference
Verify sunroof option code (S403A) via VIN decoder - panels with and without cutouts are dimensionally incompatible
F18 long-wheelbase models (primarily Asian markets) use identical roof panels to standard F10
Panoramic roof equipped vehicles (S407A) require specific reinforced panel not listed above
Context
When sourcing a roof panel for your 2011 BMW 528i F10, verify the sunroof configuration before purchasing part 41-61-7-248-415 (sunroof models) versus 41-61-7-248-416 (solid roof). This panel interchange covers all 2010-2017 F10 sedans regardless of engine variant (N52, N55, N63), but excludes the F11 Touring and F07 GT. Inspect junkyard donors for hail damage and corrosion around the shark fin antenna base, a common leak point. Installation requires cutting factory adhesive and drilling out laser welds at the rain gutters; BMW recommends sectioning at the A and C pillars rather than full replacement to preserve structural integrity. Check the roof rail mounting points for stripped threads from aftermarket rack installations.
No OEM numbers yet. Add one.
Confirmed fitment
| Year | Make | Model | Engine | Confidence |
|---|---|---|---|---|
| 2011 | BMW | 528i | 3L I6 Naturally Aspirated N52B30 (240hp) | 80% |
Available parts

Seller: Marketplace seller
$300
Asking
Contribute
The wiki gets better with every install.
Sign in to contribute2010 early production models may have pre-wiring differences for antenna amplifiers
Aluminum roof option (rare on F10) requires specific adhesive bonding procedures different from standard steel panels